Hovercraft

Poweful Hovercraft
Print Settings
Printer Brand:
Creality
Printer: Ender 3Rafts:
No
Supports: Doesn't Matter Instructions
Materials
You will need: All the printed parts, a 2212 with it's speed controller, LI-PO battery, 9G servo, some clear folder plastic and a Arduino BT ( or just an Arduino with the HC-05) Step 1 Print : PiezaAire,skirtInterior, SkirtExterior ( SkirtEXT1 and SkirtEXT2 if it doesn't fit), ChasisMotor and ChasisPrincipal (Chassis1 and Chassis2 if you want a lower print /doesn't fit) and buy the parts
( the Exterior Skirt wot fit on an Ender 3, I recommend a CR-10S)
ATTENTION: THE CHASSIS IS A LITTLE BIT HARD TO PRINT
All the prints should take roughly 1 day and a half
Motor and Speed Controller :https://aliexpress.com/item/32242144912.html?spm=a2g0s.8937460.0.0.ff242e0eDoSDCs
Arduino Nano https://aliexpress.com/item/32952790329.html?spm=a2g0s.8937460.0.0.ff242e0eDoSDCs
HC-05 https://aliexpress.com/item/1868024080.html?spm=a2g0s.8937460.0.0.ff242e0eDoSDCs
Propeller https://www.banggood.com/1-Pair-DYS-3045-3-Inch-3-Blade-Propeller-Triblade-Bullnose-Prop-Red-Orange-Yellow-Green-Blue-Purple-p-1117192.html?rmmds=search&ID=223&cur\_warehouse=CN


Category: R/C Vehicles