HP Server Power Supply Mountng Bracket Bud Industries NBF-32022

thingiverse

his is a bracket for mounting an HP Server Power Supply into a Bud Industries NBF-32022 enclosure. It uses two of the same 3D Prints mounted "facing each other". The bracket fits the HP 1200W/750W power supplies sitting in opposite directions, held in with velcro straps (slits provided on both ends and on each supply). You could also use clips or other fasteners if you like. My design plans for the two HP Power Supplies to be mounted on the lower level (with breakout boards as shown), with 3" screws attached to the lower brackets, then my Kulp 32 Bracket (Thingiverse #4754176) on top of that using standard spacers. NOTE: DO NOT USE INFILL in printing this. It's already been stripped down to essentials, and the remaining solid parts are there for stability and structure (especially the screw-in stand-offs. . . they become very brittle when not printed 100%). I used #10 - 1/2" screws to attach the mount to the BudBox (see amazon pic). I've also included the screws I'm using for risers to allow the mounts to be stacked. Attach them to the bottom board pointing up, before screwing the mount into the enclosure. Then use nylon spacers (or other tubing) depending on how much space you need. HP Power supplies need 1.7" of space. I do have an STL for those too, but you can also find others here on Thingiverse. (IGNORE the #4 screws in the picture. . . they're for the sister board that allows you to stack a Kulp32 above the power supplies)