HPA stock for sniper

pinshape

An airsoft stock to fit jg bar 10 and vsr 10.  The stock is designed to fit a 13ci hpa tank inside with the regulator. Note that the model was designed for the standard Mancraft regulator, in addition, you might need to file down the lips of the regulator a little bit in order for the clocks to sit on one line. The model has been tested by professional airsoft snipers, who all approved and said the design is very erogonomic (Might be best suited for people with long hands). After a while, the stress point between the handle and the mechanism (receiver, outer barrel etc) might give in, and so shouls be reinforced using epoxy glue\carbon quick tape\metal rods (examples in the pictures). Orientation:  Print lying down, so that the printing lines will be parallel to the outer barrel. Layer height: printed in 0.1 [mm] Material: PETG (if using ABS, account for shrinkage, PLA will also work) Printer: Ender 3 and Tevo Tarantula Assembly: 1. Prior to gluing the parts together, make sure that your 13 ci hpa tank with the regulator will fit inside (it should and have been tested), if not, file down as necessary. Do so while the regulator is set at your desired output fps, as it affects the length of it (screwing an enscrewing). 2. The model consists of 6 main parts, all of which need to be glued together (super glue is sufficient. for extra strength, use epoxy glue). *Don't* glue the last part (part 6), as it allows to insert and remove the 13ci hpa tank. 3. OPTIONAL: Reinforce the stress point between the ahndle and the trigger. 4. Use the screws and nuts supplied with your vsr\bar 10 in order to finish construction (the "Mag Holder" & "Adittion to front" should also be printed, and should be used instead of the original parts). 5. You can paint the model. NOTE: Take care while using hpa tanks, and always consult your tank supplier if unsure - wrong care of the tank puts you and others in mortal danger.