HPI Firestorm Flux Wheel

thingiverse

The hex was buggered on one of the wheels on my HPI Firestorm Flux and the spare set was taking ages to arrive, so I had a tinker on tinkercad and designed one to use in the meantime. I printed it at 0.2 with 25% infill and it held up fine on it's first run, with just a little bit of the edge breaking off but I was using the vehicle on very rough ground with lots of rocks and large stones. I'd probably print it a bit stronger if I were to do it again. You will obviously need supports. Handy for an emergency if you don't have any spare wheels lying about. I have tried to make it as near to the original fitment as possible and it seems to fit just fine, but I am only a novice at CAD and did it all in tinkercad. The fitment should be right but obviously it is a different design of wheel to the original. Hope it can help someone out like it did me!