HPI Venture battery tray mount bracket

thingiverse

So the holes line up with holes in the slider mount bracket. I took the stock battery tray and cut the mounting brackets off the sides then place this bracket down and lined the tray up on it how I wanted. I then drilled 2 holes in the factory tray to line up with the ones on the bracket then ran 2 3mm X 18mm screws through the stock tray then through bracket and into the slider mount holes (may need to drill them out a bit). Gets the battery tray lower but gives it a bit of clearance for the drive shaft and the frame curve. You will need a frame brace where the stock tray was but there are free ones already on here or other sites. My first attempt at designing a 3d part, it aint pretty but it works for me.