HTC Vive controller wall mount and charging station

prusaprinters

<p>This is a wall mount for an HTC Vive wand. It can also optionally be used a a charging dock at the same time.</p> <p>It was inspired by the existing wall mount <a href="https://www.thingiverse.com/thing:1527199">http://www.thingiverse.com/thing:1527199</a> which is also a remix of <a href="https://www.thingiverse.com/thing:1443154">http://www.thingiverse.com/thing:1443154</a> like this one. In both cases I found the original models a bit too clunky for my taste so I wanted to slim it down somewhat. Unfortunately the wall mount didn't come with any designer files so I used the original stand and re-created the wall mount.</p> <p>It still uses the same plugin parts for the different kinds of Micro USB connectors as the others though (see <a href="https://www.thingiverse.com/thing:1443154">http://www.thingiverse.com/thing:1443154</a> for those).</p> <p>This object can be used as part of my All-In-One <a href="/prints/7591-htc-vive-mount-hmd-controllers-charging">HTC Vive Mount HMD + Controllers + charging</a> mounting solution where you'll need only 3 screws to fasten the entire thing to the wall instead of the 6 needed if you mount every piece separately.</p> <h3>Print instructions</h3><p><strong>Printer Brand:</strong> Prusa</p> <p><strong>Printer:</strong> Prusa i3 MK2</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> .20</p> <p><strong>Infill:</strong> 20%</p> <p><strong>Notes:</strong></p> <p>Printed perfectly in PLA using Prusa's default NORMAL settings (with ZHop).</p> <h3> Post-Printing</h3> <p>The back plate has two holes for fixing the mount to a wall.</p> <p>If used as part of my All-In-One <a href="/prints/7591-htc-vive-mount-hmd-controllers-charging">HTC Vive Mount HMD + Controllers + charging</a> mounting solution then you only need to use the top hole, otherwise you need to use both holes.</p>