HTC Vive Tracker Belt and Shoe clip

thingiverse

this is a fully printable belt and shoe clip for the HTC vive trackers. one could also use it for any small device that uses a quarter inch camera mount screw, though there's a nub on the side made to hold the vive tracker in place. flip the clip 180degrees onto the broad top in your slicer, and use light supports. it'll be a minor hassle to pick the supports out, but nothing too bad. if your printer cant handle .2mm or better, i dont think the threaded screw will help you. you may add your own quarter inch screw to this, however.