Huawei Y5 Prime 2018 Phone Cover

thingiverse

Hi guys:) This is is a phone cover I made using Onshape for my Huawei Y5 Prime 2018. I think it turned out alright. Please note: in the pictures you can see some cracks in my phone's screen. I unfortunately dropped my phone before making the cover :( and none of the cracks were sustained after making the cover!!! I have attached 4 STL files: 1) Phone_cover - This is the one that I printed and the pictures are of. It is quite rugged and has 2.5mm thick walls all around. 2) Phone_cover_recommended_rugged - I haven't actually printed this one but all that is different between this one and the one I printed is that I have reduced the height that the side protrudes above the screen from 2.5mm to 1mm. I would recommend this one if you are looking for something rugged but still quite practical. 3) Phone_cover_recommended_aesthetics - Haven't printed this one either but this is basically the same as the first cover, only the walls are much thinner (1.5mm instead of 2.5mm). The height that the side protrudes above the screen is also 1mm like 'Phone_cover_recommended_rugged'. Not quite as rugged as the previous two covers but I would recommend this one if you are looking for a more slim cover that still offers protection. 4) Phone_cover_experimental - Would only recommend printing this one if you don't mind experimenting and potentially wasting a bit of filament. This one has been edited quite a bit. I have increased some of the fillet radii as well as reduced some of the hole sizes so I am not entirely sure if everything lines up perfectly as I haven't printed it. If it does work then I think this cover will be great. Please do post a pic if you print this one or comment if it is incorrect so I can fix it. I used a 60% infill density and tree supports in Cura to support the holes. It does take a bit of persuasion to get the phone into the cover, but once it's in, it is a snug fit:) Enjoy:) Daniel