Huge Range of Single and Double 4040 Aluminium Extrusion Wire Cable Clips Clamps Aluminum Creality Ender 3 CR-6 CR6

thingiverse

All the cable clamps I've found just popped out far too easily. These have to be slid in, but frankly you're only going to be doing this once, so removing an end-cap (or printing and screwing one in) isn't a big deal. You can use the v-slot cover I've included to space them out. Its 10mm long - but easy to resize the length in your slicer. These clamps are very quick and easy to print and don't have chamfers etc on the sides so you can probably print lots at once. I've using them with some cables that popped out of the two different clamps I've tried in the past and they've been solid with this. These are 10mm wide - but you can also make them larger/smaller in the z axis using your slicer. There is also a place with a hole in it to run a cable tie through to force a cable to go up/down - you can see how I used it one my power cable in the make. There are more and better photos in my posted make.