Huion Tablet Pen Stand

thingiverse

This is a stand for a Huion **PF150** pen, the one distributed with Q11K drawing tablets. I'm not sure if this will work with Huion's other similar pens, but it shouldn't be too hard to adjust. I made this because I wanted a stand that holds the pen much more securely than the stock stand. Included are one version with a hole sized for an 8mm*3mm round neodymium magnet, if you want to stick it to your computer tower, and one version with a flat base, if you'd prefer to velcro, glue, or sticky-tape it somewhere. This stand is also sized such that you can remove the rubber nib holder from the base of the stock stand (see last picture) and insert it into this stand, so that your nibs are handy. IMPORTANT ========== If printing the version with the hole for a magnet, use tree supports if your slicer supports them so that the hole for the magnet doesn't cave in. If printing the flat base version, **no supports are required.** This part should be printed with a **brim** since so little of it touches the bed - I had one printed with a skirt detach from the bed and get dragged around. Also included is a Fusion 360 .step file for the project, if you want to change anything about the design.