Humidity and Temperature Holder for Round Units with Battery Access

thingiverse

This is a simple holder for those little cheap round temp/humidity units that are widely available. I wanted something robust that had a stable footprint and would not tip over easily. I found other designs on here too spindly for my liking. There is also a cutout on the back to allow battery access without having to remove the unit from the holder. The cut out is designed to accept the unit snugly with slots in the correct place for the alignment clips. I should mention that the units in the photo were pulled from thee different rooms which is why they all read differently! They would have matched after five minutes Mine are printed face down in PLA with a gyroid infill using a brim. The file is an STL and I do all my 3D stuff on Blender. If anything complex is involved, I 2D draft on DeltaCAD and import the DXF file into Blender, as this speeds up my workflow.