Humpty Dumpty game toy

thingiverse

Started as a simple project. Until I realized the bottom of the blocks needed to be wider in wall thickness. It was tough to stack them. The base and uprights are printed diagonally. I didn't design a Humpty, my son/we use an Avengers figure. I also left a 1mm groove in the bottom of the base, I poured Loctite GO2 glue. It took about 3 hours to dry. It protrudes just enough for some adhesion to the table. The uprights and base are about 300mm long. The blocks 25x25x62 if I remember right. I did 20% infill. Some post sanding on the uprights might be needed, height adjustment, block fit also. Kinda like building a model kit. Make sure the uprights are square.I used CA glue. Lately I have been using a brim on everything, Had two prints move on me, I printed 5 blocks at a whack. My 5 year old has a short temper, (must be moms DNA). This game has helped his hand eye dexterity a lot.He is figuring out strategies also. Or he is just growing up? Anyway, Have a good day.