HY-SRF05 Ultrasonic Range Finder Mounting Bracket

thingiverse

This is, essentially, the same as the HC-SR04 Ultrasonic Rangefinder Mounting Bracket by Matter153. I widened the connector cut-out to account for 5-pin design of the HY-SRF05 sensor (as opposed to the four pins of the HC-SR04 sensor). Obviously, Matter153 did all the real design work here and I just made a minor tweak. If you want to send a tip, please send it to Matter153. Print Settings Printer: Prusa i3 MK2 Rafts: No Supports: Doesn't Matter Resolution: .200mm Infill: 20% Cubic Notes: Printer is a Prusa i3 MK2. Printed in PLA or PETG, it can be printed as is. Printed in ABS, scale it up slightly (I used 101%) to account for shrinkage. I prefer to print this in PETG as it is more flexible and makes it easier to pop the sensors into (and out of) the brackets. Post-Printing Mount with #6-32 screws. Matter153 says "If you cut a piece of a foam paper plate to put behind the sensor it helps considerably with vibration if you are using this with a robot." I haven't done this myself, but it sounds like good advice so I am passing it along.