Hybrid Pusher For Nerf Stryfe

prusaprinters

<p>A hybrid pusher to fire both half-length darts and full lengths from the same blaster! All other designs i found or bought either were too unreliable or weren't compatible with the OFP anti-jam lid.</p><p>Print at 1% scale</p><p>Credit to Jackskidding for the pusher dimensions.</p><p>19.2.20- Added V2 with shortened half dart pusher for improved reliability. Removed V1 as it became obsolete.</p><p>19.2.20- Added V3 with slightly shorter half dart pusher and more shaped pusher profile.</p><p>20.2.20- Added V4 with further shaped pusher, dart 'flanges' and a larger screw hole for ease of installation</p><p>20.2.20- Added V5 which further improved on the design ideas of V4 and V5 higher tension, which is a more robust design but as of now untested.</p><p>23.2.20- Added V6 High Tension which is the most reliable pusher yet due to its improved pusher design. Tested V5 high tension. It's as reliable as V5 but more robust.</p><p>Versions TL;DR</p><p>V3 has been tested and performs well, with some jams with worn darts, hence V4 and V5, but is as good as the 2D pusher profile allows. A simple, quick print.</p><p>Use V6 for more reliable results, however note that it is very slightly more fragile than V3.</p><p>I am not responsible for any damage done to the blaster, darts, or anything else.</p><p>Category: Toys &amp; Games</p>