HyperCube Custom Parts 300x300x300

thingiverse

I built my HyperCube (https://www.thingiverse.com/make:332719) based on the original design by Tech2C but up scaled it to 300x300x300 with dual Z axis and 10mm Y axis rods. This meant I needed some customized parts. Some of these are a remix from the original 8mm parts but resized to 10mm. Even though I designed some of them from scratch, like the Y10 Shaft Clamps, they were based off the original dimensions from Tech2C. The other remix is from henryarnold and his 2020 LED Lighting Mount. I created a version that lifted the fixtures above the extrusion in order to place the lights on all 4 sides. The cable tower is to provide a place to fix the cable bundle to the extruder to help act as a strain relief. The bed brackets were needed to help move the bed around the build platform so that the extruder would at least start out with 0,0 on the bed. Finally, with the addition of the 10mm Y rod the existing Y endstop would not work. Creating a larger version of the 8mm clamp wouldn't work as the larger diameter of the 10mm rod simply pushed it over too far to nestle into the motor bracket. As such I created a custom part to allow mounting the endstop to the extrusion instead of the Y rod. This positions the endstop switch to strike the face of the XY Joiner. Something else you may fined worthwhile is the Hotend Wiring Loom Support Bracket I designed. https://www.thingiverse.com/thing:2426833