Hyperlite Floss 3.0 AXII Micro Mount

thingiverse

AXII Micro (U.FL or MMCX) mount for the Hyperlite Floss 3.0 from Pyrodrone. Would fit other quads with 5mm standoffs at 31mm spacing, just be aware that the circular section for the antenna does protrude above the standoffs before it clears the aft edge of the standoffs. Edit 6/24/19: The additional hole at the rear right of this mount is for a Pyro "Forever Tube" that is used in conjuction with the lower antenna mount that I designed as well (see photos). If there is interest, I can post the antenna tube mount file as well. Edit 11/16/19: Added a new file "Hyperlite_Floss_Lite(27mm)_AXII_Micro_Mount_V10_45deg.stl". This should fit the narrower standoff width of the Floss Lite (27mm). Edit 1/2/2020: Added a new file "Hyperlite_Floss_3.0_ForeverTubeMount.stl". This is the lower antenna mount as seen in the images. Only currently available for the 3.0, not the lite version. Printed in Sain Smart Teal TPU (95A): https://www.amazon.com/gp/product/B07F2YW5YL/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1 Print from the bottom of the mount up, no support needed. Part designed in Inventor, and planes in Inventor do not match typical 3D Printer slicers, so it will need rotated in your slicer. Two versions available - 45 degree and 55 degree. 55 degree is closer to parallel with top and bottom frames, whereas the 45 degree is more perpendicular to the frames. Frame it is intended for: https://pyrodrone.com/collections/5-inch-frames/products/hyperlite-floss-3-0-race-frame Antennas it is intended for: https://www.getfpv.com/lumenier-micro-axii-mmcx-5-8ghz-antenna-rhcp.html https://www.getfpv.com/lumenier-micro-axii-mmcx-5-8ghz-antenna-lhcp.html https://www.getfpv.com/lumenier-micro-axii-u-fl-5-8ghz-antenna-rhcp.html https://www.getfpv.com/lumenier-micro-axii-u-fl-5-8ghz-antenna-lhcp.html