IC-705 very portable table stand.

prusaprinters

<p>This is an ultra portable desk stand for the IC-705. It breaks down small enough to fit in a small envelope and take very little space in your go bag or back pack.</p> <p>Print two of the cross member parts, and two of any of the angled sides you want.</p> <p>Note: if the notches are too loose with your print, the cross member named "tighter notch" has a notch that's 0.2mm smaller.</p> <p>There are four side pieces, one each for a different angle on the radio. You can have it angled up at 5, 10, 15, or 20 degrees.</p> <p>To assemble, just put the notches together. The side pieces have an embossed number to indicate the angle the radio will be tilted up. The end with the number goes to the rear.</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Anycubic</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>All-metal Mega</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>0.2</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>25%</p></div> <p><strong>Filament:</strong> unknown PLA Black</p> <p><br/> <p class="detail-setting notes"><strong>Notes: </strong></p> </p><div><p>An easy and quick print. I used .2mm layer height to get good strong parts.</p></div> </p></p></p> Category: Electronics