Ignignokt and Err magnet

thingiverse

Tried to keep the shape about right, but I had to enlarge Err a bit to make the magnet fit. They should puzzle-piece together to form the quad-laser (sans quad-laser). Instructions 1/8" x 1/4" inch disc magnets magnets The two color, non-dual extruder or pause way using cura: Print the bottom/base. For the "whole".stl - setup your slicer to remove the bottom 3.5 mm (3.6mm if you do 0.2mm layer height) for ignignokt and 3.0mm for Err Set your start height the same distance as the removal height for each character Also, I set my fill to 100% for the top layer because my filament is translucent.