IKEA Chair Wheel

thingiverse

These chair wheels were made to replace my misplaced IKEA chair wheels. They fit perfectly for a 10 mm diameter stem. Disclaimer: This is just a model. They will not support your weight. I am actively working on re-designing this so that it might support a person. Instructions Bill of Materials: 2x "new wheel" 1x "connector" 1x "wheel shaft" 1x "revised middle wheel" As of right now, the "middle wheel" still needs to be printed with supports--for best results, print on the flat end. Multiply this by 5 if you'd like your chair to have five wheels. I printed in PLA in low quality. Some drilling may be necessary around some of the holes if the shafts are not fitting, or you may upgrade to a higher quality print. These are intended to snap together, with some application of force (I might suggest a few taps with a hammer, but be careful).