Ikea Koppla Power Strip Mounting Brackets (US)

thingiverse

This is a really quick design for clip-on brackets for the Ikea Koppla Power Strip (US version) so I could attach it to my Lack table 3d-printer cabinet. The design of the brackets make the entire power strip sit flush with the surface the strip is mounted to so the clips need to be on the outlet side. The specific strip can be found here: http://www.ikea.com/us/en/catalog/products/70086401/ (700.864.01). I designed it in Tinkercad using a basic box representing the strip. I did engineer the clip-on parts to have a slight edge to snap into the lines on each side of the strip. I got the screws as close as flush as I could, using #10 x 3/4 in flat head wood screws I had lying around from home depot. This is a very tight fit! Which is good as it will not slide around, however be careful installing it as the pointed parts could be sharp. These clips will snap into place when the fit is correct. This is based on my Cura settings and screws of course so I hope others get this very pleasant snapping experience as well! As a bonus, I was pleasantly surprised to find out that my Raspberry Pi adapter fit snugly between the clips (last picture).