Ikea Lack End Table Logitech C270 Webcam Mount

thingiverse

This is a little bracket to hold your Logitech C270 webcam. It clips on fairly securely with no hardware, but has accommodations for 3mm screws to tighten it down. The camera fits in fairly snug without hardware, but it has an accommodation for a 3mm screw. I printed it in PETG. I regret that. I will reprint in PLA as PETG tends to creep over time and loosen its grip. It doesn't hold the camera up high enough to see the build platform if attached to the platform your printer is sitting on. It only works hanging from above. I recommend a Logitech C270 focus adjuster mod, as it was too close to my bed for the preset focus. The adjuster mods are easy to print and easy to install on the C270 - no cutting or anything like that. Highly recommended mod to go with this part. Prints without supports if you lay it flat on its back.