Ikea Lack Table corner brace.

thingiverse

This is a corner brace for stacking two ikea tables on top of each other and bolting them into place. This was inspired by the instructable http://www.instructables.com/id/3d-Printer-Enclosure-from-Upcycled-Furniture/ and I made these corner brackets to facilitate stacking them without needing to bolt the top table in place. The brackets will hold the top table in place, but the hole is there to bolt it in, if desired. I plan to not bolt mine in so it becomes a dock for me to place my carry along top enclosure made out of the other lack table. Print Settings Rafts: Doesn't Matter Supports: No Post-Printing Holes are in both top and bottom of brackets, on either side, I'm only going to use the bottom hole to make the top table removable.