Ikea Lack TV bank as (Prusament) filament storage
prusaprinters
<p>I wanted to use two existing Ikea Lack TV banks for the storage of original Prusa filaments within their original packages. The Lack TV banks should be modified in such a way, that a removal at a later point in time is possible without any visible damage to the banks.</p><p>→ This lead to the design of the attached 60 mm spacer.</p><p> </p><p><strong>Required material (per TV bank):</strong></p><p>1x Ikea Lack TV bank (Ikea part number: <a href="https://www.ikea.com/de/de/p/lack-tv-bank-weiss-00450088/">004.500.88</a>, WxDxH: 90 x 26 x 45 cm)</p><p>32x Universal screw (4 x 25 with pan head) <a href="https://www.amazon.de/Dresselhaus-JD-79-Universalschraube-Halbrundkopf-Kreuzschlitz/dp/B00CML1XNS/ref=sr_1_10?__mk_de_DE=%C3%85M%C3%85%C5%BD%C3%95%C3%91&dchild=1&keywords=universalschraube%2B4%2C0%2Bx%2B25&qid=1621860490&refinements=p_89%3ADresselhaus&rnid=669059031&s=diy&sr=1-10&th=1">Amazon link to typical screw type</a></p><p>8x attached spacer (should also fit for other sizes of the same TV bank type, but I have only tested this with the 90 x 26 x 45 cm bank)</p><p> </p><p><strong>Installation Instruction:</strong></p><ol><li>Remove the lower (middle) plate of the TV bank.</li><li>Unscrew the four legs of the TV bank.</li><li>Screw two spacers on each end of each of the four legs of the TV bank (4 screws per spacer = 8 screws per leg).</li><li>Remove the original centered Ikea screw (connector between each leg and the upper part of the TV bank) out of the desk or each leg -depens on, where the screw is located after removal of a leg.</li><li>Screw the original centered Ikea screw (out of step 4) into one spacer per leg.</li><li>Screw each leg with the original centered Ikea screw (that is now screwed into a spacer per leg) into the lower side of the upper part of the TV bank.</li></ol><p> </p><p><strong>Note for stacking:</strong></p><p>If you want to stack two TV banks (as shown in the first photo) you can use e.g. the following adapter: https://www.prusaprinters.org/prints/11146-ikea-lack-stack-adapter</p><p> </p><p><strong>Print Instructions (tested without any issues):</strong></p><p>Print orientation as shown in the attached STL file</p><p>PLA</p><p>0.3 mm</p><p>30% infill</p><p>No support</p>
With this file you will be able to print Ikea Lack TV bank as (Prusament) filament storage with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Ikea Lack TV bank as (Prusament) filament storage.