Ikea Ledberg light bar bracket and feet

thingiverse

Brackets and feet for Ikea Ledberg LED strips. I needed a solution for my printer not being in a full enclosure so I came up with this. I wanted the U-shaped configuration for my MP select mini. First, I started from another designer's connectors so I could wire the bars together. I used this: https://www.thingiverse.com/thing:121247 Once that was working, I made feet and connectors for the frame to hold it upright and lock it into a right angle. Now it can freely stand upright on its own. Feet: Two versions, a smaller foot can stand upright, but might tip, second one doesn't tip at all. I found even just using one large and one small is sufficient to keep the assembly standing upright. Both feet have two sockets on the bottoms for a 3x6mm magnet to press into. I've tested this on walls and ceilings and it holds the lights even with just one magnetic foot. Corner braces: One smaller, simpler design for the lights to be right up near each other, the other larger one, also built with both screw holes as well as 3x6mm magnet sockets, so it there are alternate mounting options. For all of the parts, the Ledberg bars can either slide into the channel(there's enough space for the primary electrical connector as well), or they can snap into the front edge of the channel (There's a channel on the LED strips it will snap into) for when you need a firmer grip, which I found works well on the corners.