IKEA Markus chair handles

prusaprinters

<p>IKEA Markus is a great office chair with decent part quality and very long warranty for an attractive price. However, there is one design flaw – <strong>the original armrests cannot be adjusted in any way</strong> and will most likely hit your desk. If you want to work without heavy original armrests, but still need to grab a chair from time to time or level it under yourself during the work, I have prepared an <strong>easily printable alternative. Just print it twice and use the original screws.</strong></p> <h3>Print instructions</h3><h3>Category: Replacement Parts Print Settings</h3> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.2mm</p> <p><strong>Notes:</strong></p> <p>• Use high quality PLA or <em>stronger material</em> (from CPE+ to composites) depending on how you plan to handle the chair.</p> <p>• 0.2mm layers are OK here, but use <em>more surface walls</em> (like 5) and <em>more dense infill</em> (cubic, gyroid etc.) near the mounting holes. See the picture of sliced part.</p> <p>• <em>NO SUPPORTS are needed</em> as the only supported areas are already solved in the model thanks to single-layer bridging. (But DO NOT rotate the model on the buildplate upside down. ;-) ) Remove the thin bridging in the holes with knife easily before mounting phase.</p> <p>• Use some <em>matching (or contrast) colour</em>. Very nice is Vertigo Grey or any anthracite shade.</p>