Ikea Norden Lock Inset

prusaprinters

<p>Our IKEA Norden table (which is a fabulous table) lost one of the insets that are used for locking it in its extended position. I measured the hole and did a simple version in OpenScad. It fit quite snugly at my second try, so even though I was planning to add screw holes, I decided not to, since the forces on it are sideways.</p> <p>Instead of the crossbar in the original design, I made a rounded plate at 45 degrees angle, to make it sturdier and easier to print.</p> <p>For missing snaps, see <a href="https://www.thingiverse.com/thing:2614838">https://www.thingiverse.com/thing:2614838</a></p> <h3>Print instructions</h3><p>If your printer is not well calibrated, this may end up being too thick. In that case, reduce the diameter by 0.2mm or so.</p> <p>If you have any elephant foot at all, you will need to file that off.</p>