IKEA Nävlinge bracket for prusa mini

prusaprinters

<h3><strong>IKEA Nävlinge bracket for prusa mini</strong></h3><p>Bracket for illuminating the print bed of prusa mini printer. It is design to attach onto the printer z-axis. The lamp position is adjustable to illuminate the print bed. I also designed a cover to hold to cable and lamp power switch in place.</p><h4><strong>Disassemble IKEA Nävlinge spot</strong></h4><ol><li>unscrew and remove small cable holder screw</li><li>remove wire heat shrink tubing and cut both wire at the soldering point</li><li>unscrew lamp arm from clamp (the arm is also glued in - may be it is a bit stiff)</li></ol><h4>Assembly instruction</h4><ol><li>push the cabel through the the cabel guide and pull it out upwards</li><li>attach cable ties as strain relief and pull back cable inside the holder</li><li>screw the lamp arm in and pull up lamp wire upwards</li><li>solder cable wires again</li><li>use heat shrink tubing or similar to isolate soldering joints</li><li>push wires back into the bracket</li><li>attach hole cover&nbsp;</li><li>use T-Nut stones to attach the lamp to prusa mini z-Axis (T-Nut see additional parts)</li></ol><h4>Additional parts</h4><ul><li>2 - M3x10 screws (cylinder screw)</li><li>shrink tubing</li><li><a href="https://www.ikea.com/de/de/p/naevlinge-klemmspot-led-schwarz-00449877/">IKEA Nävlinge Spot</a></li><li><a href="https://www.prusaprinters.org/prints/67166-t-nut-stones-customizable">2 - T-Nut Stones</a></li></ul>