Ikea Skadis Multimeter Holder

thingiverse

This is a simple box with a cutout that I made to hold my multimeter. If you look at the back of the box in Thingiview, you'll see two small loops. I've made a bit of a modular setup, using the basic attachment hooks that I've included. Choose one of the basic attachments and print a pair of them. It doesn't really matter which one you choose -- the only difference will be that the box will sit a little higher or lower. You'll also notice that there's a little nub coming out of the back, down at the bottom. This is to give the box a bit of extra stability so it doesn't rock or put extra torsion on the attachments. I went with seperate attachment hooks and holders so that each could be printed as easily as possible, and so that the hooks were less likely to break when attached to the Skadis pegboard.