IKEA TISKEN towel holder hooks

thingiverse

These are hooks that can convert an IKEA TISKEN towel holder to a coat or dress hanger. There are three design that can fit on the holder: - Big hook with lock: it fits on the bigger section and has a small bump that lock it onto the holes used for setting the length of the holder. It should not be put on the hole that locks the two sections together. - Big hook without lock: same as before but it can slide freely along the holder. - Small hook: it fits only on the smaller section and it can slide between the side of the holder and the beginning of the bigger section. I use the big hook with lock and the small hook in order to have both functionality on the same holder, but you can use whichever combination of all three models. I have printed those with 100% infill in order to have them really sturdy. Also, you will need to force the openings a bit when you get to install them. In order to make the hooks snuggly fit to the holder and to make them in a single print without any mechanism at all, this is the best way to have them firmly locked. I recommend to use PLA or ABS rather than PETG as it is less resistant to flex and the initial install and the weight of some clothes could damage it. Anyway, once installed, the hooks should not have any constant stress applied by itselves (they are not forced in some way to stay on the holder)