Improved nerf blowgun revolver

thingiverse

Firstly, look at the original under the "remixed section" before you consider printing this. Basically the same as the original, with 3 improvements. Firstly, much tighter holes for the darts. This will hold whistler darts snuggly, so that they don't fall into the barrel or out of the back if you point it upwards. If fact, depending on the precision of the printer, you may need to sand down the dart heads so they don't get stuck. Also, it helps if you grease/oil it before use to help the darts not get stuck. Secondly, the pieces fit together much tighter now. The original had a few areas that air leaked out of when you fired, which I have fixed. Once again, you may need to sand down the front or back of the chamber as well as grease it to allow smoother rotation. Lastly, the connector to the pipe is extended out. If you put a single layer of duct tape over the pipe part, it will now fit snug and have a near airtight seal, while still being removable. I have found that with these improvements, my range and accuracy is about the same as it is without the revolver, giving me no reason not to use it. I may mess with this a little more in the future, but for now, happy nerfing!