Inboard M1 Controller Flashlight Mount

thingiverse

UPDATE: I added some ribs to the key to make a tighter fit. I also added a 2nd STL that includes a mount for a TrackR Pixel. This is a flashlight mount I designed for the Inboard M1 electric skateboard controller. It takes the place of the standard rubber handguard using the same screws and holes. No permanent modification is required for the controller. I designed it to be used with the $13 "Vont Bike Light" which is available on Amazon (link below), but it can be used with any flashlight with about a 17mm diameter. It requires an M3 nut and bolt. I find this prints best when printed with Cura Tree Support (especially when printing the TrackR version). I also like printing it with a raft. Note: you'll need to rotate the model so the hole for the flashlight shaft runs verticle when printing. https://amzn.to/2MNG6cm