Indoor Pet Cage Clip

thingiverse

Replacement clip for indoor large pet cage. I based all the dimensions on a remaining original I had. prints in about 10 minutes and fits perfectly. The original was a slightly more durable plastic so if printing in PLA I'd perhaps scale it up by 1-2% as it's quite tough to clip on and I did break one clip trying to fit it (the others went on ok). if you're printing in abs you should be fine as that has a bit more flex. 100% infill is a must! EDIT: Please Use V2 file - I found the gap to be a little tight and some clips were snapping, also I have shortened it a little bit to account for misalignment of the adjoining cage panel. it's a much better fit now. I have also now started working on the corner clips that attach to the bottom however getting them right is proving to be a bit problematic at the moment: