Injora rock buggy rear light bar

thingiverse

<h2><b>17/09/2021 - V2</b></h2> - Fixed STL orientation - No longer needs supports so it's easier to print - Fixed fitment issue where the top of the lightbar was hitting the top body panel - Created a front diffuser to make the lights dimmer. (fits on both V1 and V2 versions)   On the diffuser, higher infill and more solid layers will make the light dimmer and vice versa. I'm using: - White PLA (other light collors also may look good) - 20% infill - 0 top solid layers - 2 bottom solid layers <hr> Replaces the top rear support beam. <s>Used support on the build platform only.</s> <b>→ No longer needed on V2</b> Also in the video shows the RCModelsandMods front light bar, take a look at it too! https://www.thingiverse.com/thing:4897517 I used 6x 5mm 22500mcd LED's and sanded them down a bit to make them smaller (look at the photos and also be careful to not expose the metal parts of the led's). I covered the rear of the led's and the wiring with black hot glue to avoid light being seen from the front. Led's are wired in series of three as shown in the picture above and powered by the BEC voltage of 6.4V