Inkbird Temperature Controller Box

thingiverse

I wanted an all-in-one case for my inkbird temperature controller for use with home brewing. I designed this to be able to have the controller visible from the front, and the outlet ports on top, using standard duplex outlets, not the single rectangular opening type. The power supply cable and the temp probe cable enter / exit the box from the back side. M3 hardware secures the top to the bottom at the 4 corners, and your standard outlet hardware should work for the outlet. This will fit on a 200x200 mm print area. ===================================================================== If you have found this item useful, consider contributing to me at: http://paypal.me/MarkGarety Any amount helps. Thank you so much! Print Settings Printer: Folgertech 2020 i3 Rafts: Doesn't Matter Supports: No Resolution: Doesn't Matter Infill: 10% or a little higher Notes: It doesn't require a raft, or supports. Any print resolution that you typically print at will be fine with this. I printed mine with 10% infill, and it was a little bit bendy, but still worked. For a more rigid box, increase the infill