Inland (MicroCenter) filament spool clip

thingiverse

Yet another spool filament clip for Inland (Micro Center, made by Sun) 1.75mm filament. Others work fine, I wanted something "just a little better". This one snaps on and doesn't let go, put it on and leave it on, it won't snag the filament as you print. After removing filament from the hotend, CLIP the end of the filament (or it won't fit) and poke it into the clip (don't move the clip), extended a fair amount (so it won't slip out by accident). It the clip falls over when you print it, set the skirt distance [from object] to zero to add platter surface area. It is important to remove any flash from the inside of the clip, especially around the filament clamp, so the clip works correctly. This can happen at the heat bed.