Inmoov Back for 2017 CHUWI Hi8

thingiverse

After using this tablet for a while, I would recommend against using it. It is too weak and too slow. If you are looking at this thing, you are in the same spot I was in. All of the computers recommended are no longer available. I purchased Chuwi Hi8 in June of 2017 and it is now smaller and it will not work in the original back. I first tried printing a frame for it and this did not look good. In addition, the plugs stick out on the left side into the original frame. I made these by converting the STL into solids and adding a frame and combined them. I then needed to chop out a hole for the wire and to have access to the power and volume controls. This is far from perfect, but it is better than using duck tape. The STL to Solid conversion created some small curves that were not there on the sides of 2 pieces, This is not noticable as it is an outside edge. The filament I used in the print job was garbage so the edges are very rough. I need to reprint with better filament.