Inmoov_Bust

thingiverse

After printing a new skull for my inmoov using my new neck plate, https://www.thingiverse.com/thing:4638985 i decided i was going to use my old skull to make a partial robot build. So i set about designing a new headstand that would use the pistons to support the head and make it easier to work on the head and tinker with things. https://www.thingiverse.com/thing:4670770 Before i even printed my head stand i realized i wanted a little more of the robot printed. Rather than using a separate enclosure to hold the needed electronics. So i designed this to accomplish two things one give another milestone that people could build up to rather than printing just the head on a head stand or printing the entire robot. So i tried to design this with as few pieces modified as possible from the original inmoov design to avoid having to reprint pieces down the line if you wanted to print more of the robot. but the design needed enough of a base to provide room to hold the electronics and be able to use all the pistons for the neck. In the pictures my modified pieces are in green, with the exception of my front chest covers and clavicle covers, The rest of the parts in white are the original inmoov parts. The front spacers are meant to be screwed into the Kinect Side holders on either side and up into the pieces that are normally over the kinect, I also included in these pieces grooves to allow you to run wires between the sections and back into the robot as well. Enjoy and as always Post your makes