intensewalkera GoPro Loveseat Vibration isolation mould - cast -template v2.2

thingiverse

Revised to 2.2 - tab hole positions moved to allow better bolt access Revised to v2.1 a few minor tweaks , added a ribbed back, tapered a few edges to allow the silicone to pour in better. This is based on the team blacksheep loveseat , used on multicopters to isolate vibrations to the gopro camera range (will work with others). its a rough design, i will comeback and tidy up the design of this, once i get chance.i would like to have it hinged and free from none 3d printed parts. i.e lose the bolting up arrangement. http://youtu.be/OaK46BK0zEY bolt the two parts together with m3 bolts, don`t over tighten. mix up your silicone and catalyst and pour. i used 100g of rtv 2020 silcone/catalyst checkout how to make the rtv silicone mix on google etc, there is plenty of info on there, you can see from my attempt, that i had too much air get in, this was totally my fault due to it being my first time using this silicone mixing. i know my next attempt will be far better, now i know what i am doing! i used medium hardness silicone as a guess, i have not tested it in anger yet but i will get round to it shortly. Instructions 0.2 layer height with a high infil value to ensure the mould turns out a good quality finish