Internal Window Tilt Clip

thingiverse

I had some window tilt clips break on me and needed replacements. I didn't like that the original design from the manufacturer had parts that didn't work for both left and right sides and decided to create one that only had 2 parts instead of 4 unique parts. For each clip, you should only need a small spring (could be stolen from a pen if you don't have your original hardware springs), a 12mm m3 bolt and 2 m3 nuts (one of these could be replaced with some washers). I put one m3 nut on the m3 bolt and screw it all the way to the head, then put the spring in the housing, slide the clip in and put the bolt through the hole before screwing the other nut onto the other side of the clip. Before printing, this clip fits into a slot that is ~66mm long and ~14-16mm wide.