Intex pre-filter cover wrench

thingiverse

The big Intex sand filter has a pre-filter with a clear cover. The cover needs to be removed to clean out the leaf basket and to bleed air out. I found it difficult to remove by had, and my big wrench was breaking off the tabs on the cover, so I made this. It has a square lug on top for using with a big wrench. It also has a 3/4" hole through the side for inserting a wooden dowel if you don't have a big wrench. It was printed on an Anet A8 with the following printer settings: - MakerGeeks PLA, 230 C nozzle, 50 C bed - 0.6 mm nozzle - 0.25 mm layer height - 8% infill, 3D honeycomb - 3 perimeters (1.8mm) - Top & bottom 6 solid layers (1.5mm) - support X-Y separation 2mm - Print upside down with supports on build plate only - no brim I used the cheapest filament I had just as a prototype, but the print came out perfect and works just fine. I don't feel the need to reprint in PETG.