Iphone 4/4s Otterbox Commuter case Locking Angle Holder

thingiverse

Ever get tired of the fact that you get one of the best cases for your phone, and you just can't use the phone holder you bought. Do you get frustrated with the Universal Car Holders, that either hold too well or not at all. Then find out after getting a ticket, that your state doesn't allow or they limit placement of windowed suction cup devices. Well here something that should help. This holder is designed to hold your iPhone 4/4s in a OtterBox Commuter case snuggly while being something that can be mounted anywhere. THis was a total redesign and should be looked at closely. Springs are limited. Will be placing a customizer mount point. Update: Now has new pieces that reduces amount of metal parts to hold together and also Bike clamp. I have started to use nail polish remover to glue pieces together. Instructions I printed these at .2mm level at 20% 2 wall fill of ABS. This uses 8# screws, nuts, washers and locking washers. The Spring is 9.5mm x 2.9mm x 1mm compression spring. All items that need to be printed twice are marked with "x2" at the end of them. The Locking pin is printed flat. All parts have now been set in the way they should be printed, on the platform.