Iphone 4 vent mount with charger

thingiverse

I wanted a new Iphone holder for my 4runner and it had to have the ability to contain the charger. So I remixed this simple design. I split it into parts as I typically do not like to print with support. Now the real question is if my wife wants one for her car. Instructions Print both parts in ABS. PLA will become too soft or melt in your car. I found a use for the scrap i cut off of the 3mm filament after I remove it from the extruder. It makes a perfect pin. The abs crushes in place with a bit of pressure from a pair of needle nose pliers. I included a cut in the base for the wire, but as you can see from the pictures, my cable has suffered from years of abuse and is wrapped in electrical tape. The plug slot may be a half of a mm too big. Wrap it in tape once to produce a tight grip. This fits very firmly in the 2nd slot of my 4runner vent.