iPhone 4s Slim Case Blank

thingiverse

I have downloaded a few iPhone cases and all of them have fit issues, or are hard for the slicers to get to print properly. I made this case to fit an iPhone 4s super snugly and it is pretty thin and easy to print with no support. I am using this as a bed for some additional hardware (gears so far). This is just a nice blank place to start. Enjoy! Instructions Print this with: .20 mm layers 4 shells total raftless with no support 230 / 110 temp 80 / 150 speed You have to slide the top of the phone in first, and then snap the bottom sides around the phone. Removal is the reverse.