iPhone 5/5S/SE (1st gen) screw-on tripod mount

prusaprinters

<p>A simple screw-on tripod mount for the iPhone 5/5S/SE (1st gen).</p><p>Requires no screws/nuts to assemble. However, it is recommended to put a bit of foam on both sides, otherwise the phone will be quite loose while in the mount.</p><p>I'd also recommend putting a tiny piece of thin foam on one side to prevent it from sliding around.</p><p><strong>NOTE: The 3MF preview on this site for this model is broken, since it uses negative volume!</strong></p><p><strong>And print with the brim enabled. Please.</strong></p><p>Made entirely in PrusaSlicer with cubes and an already available <a href="https://www.prusaprinters.org/cs/prints/51463-tripod-screw">tripod screw</a> model as a negative volume modifier. The license of this model matches the one of the original tripod screw.</p>