iPhone 5 Car/Cupholder dock

thingiverse

iPhone 5 Holder for your car, I designed it with Autoscad for my Nissan Altima, but it will fit in any cupholder 70mm wide at the bottom and 80mm at the top or larger. I couldn't find a good dock, so I designed this one with the following features in mind: -Coinholder, the bottom part is curved so you can easily pull out the coins. -Penholder -It has a good viewing angle and a slot for the charging cable! I designed assuring that it would print good with no support needed. I hope you enjoy it! Instructions The dock is composed of 2 parts: -1. Base: the base is the part that goes into your cupholder. This is the file "CupholderStand_part1_v5.stl". -2. Phone holder: this "plugs" into the base, I put it separate so it would print better, and so I could design variants for different cases. I included two variants: -2a.Otterbox Commuter case. This holder has room for a case around 14mm thick and 65.5 mm wide, it's the file "CupholderStand_part2_v5commuter.stl". -2b. Speck candy case. This holder has room for a case around 12mm thick and 65.5 mm wide, it's the file "CupholderStand_part2_v5speck.stl". -Infill: I'd recommend 20% infill. Case of slightly different dimensions will most likely fit.