iPhone 5 Case in two parts - Doctor Who Gallifreyan pattern

thingiverse

iPhone 5 Case in two parts, suitable for printers with smaller build areas, was designed and printed on an Up! Mini. Instructions Print in PLA at 0.2mm layer size, no raft, no supports, face down on painters tape/kapton tape then peel off when done. Printing face down with no raft causes the pattern to squish together a little more and look nice however you may need to remove a small amount of overflow around the corners or reconfigure your printer to lift the head up by 0.1-0.2mm if it comes out too muddy and squished. To fit, slide the bottom half on first, then slide the top piece on (making sure to lift/wiggle the section over the mute and volume buttons) then gently bend up the locking sections and when the two ends meet, gently push on the locking sections until they pop together.