iPHONE 5's Lifeproof Stand/Dock

thingiverse

I have been looking on here for a while now for a iphone 5 stand that would work with the Lifeproof case and never found one. So I Finally decided to Design one myself. This Stand/Dock works with iphones that use the newer Lightning connector: 5, 5C, 5S. Stand can also be used without the Lifeproof case installed. I designed this Stand for easy on and off by allowing the connector block to pivot. The connector block also engages into the lifeproof case several mm's for added strength and less stress on the lightning connector. The Base Stand currently requires support for the pivot cavity (I plan to do a support free version soon). The base and Cable block can be difficult to snap together. The Cable block may also need some sanding to allow engagement of the Lifeproof case. Be careful when installing your cable so you dont damage it. Enjoy Update: Added Stand Bases with built in support for the Pivot cavity. One with rear logo indent and one without logo. I recommend you use one of these base files instead of the older non supported ones, since cleanup will be much easier with these. Update: Added different base configurations for the rear logo. Added parts for Vibration issues. Printed with Flexible filament. E.G.: Ninja Flex I noticed that the phone vibration would make an annoying noise against the back of the phone so i printed a flexible cap to add to the top to prevent this. Also added small feet to bottom for extra surface grip. Next update will be support free. Instructions Please use new Stand base's with support built in for the pivot cavity, It makes for an easier cleanup than if you generated support material. Also print the cable block, install cable, then snap base and block together. It may be difficult to snap together.