IPhone 5S/SE Ferrari Case

thingiverse

This is a Ferrari style case for the Iphone 5S or Iphone SE. It is designed to print in ABS to allow it to flex some but also be rigid. Right off of the print bed, it was a bit tight in some places, so I just used an exacto knife in those places to shave a little bit off, and then it fit beautifully. When putting the phone in the case make sure to insert the sleep/wake button on the top, and the volume, and slider on the side of the phone into the slots on the case first before putting the rest of the phone in. To take it out, just push the phone out a little bit through the Ferrari logo on the back, and then at the bottom of the phone work it out until the bottom is out of the case. Then just slide it out. It goes in and out very easily, but also stays in the case wellI also added a lip to the case to keep the screen from ever touching anything (like the top of the desk when you put it down). Overall, I think you will really like this case, and it is perfect for any car fan!! Print Settings Printer: Flashforge Creator (Dual Extruder) Rafts: No Supports: Yes Resolution: 0.2mm Infill: 90% Notes: This prints very well, and pretty quickly, and is strong, if you use a high infill. It is very important that your infill percentage is high enough other wise this case may not print properly and/or may break.