iPhone Holder for 2013-2014 Mazda CX-5

thingiverse

This was my first try at a Customizer print. I didn't realize that the STL files I need to attach don't work yet in Customizer. I guess you need to have OpenSCAD, download all my files, then export as STL to print. If anyone knows how to get around this, please let me know. I made a customizable iPhone holder that clips into the vent of a 2013-2014 Mazda CX-5. This should allow you to customize the phone holding part to fit your case or bumper, if you use one. The part that fits the car is not customizable, as this would be incredibly difficult to make it work for any car. So, if you have the same care as me, I hope this works out for you. Please follow all applicable laws for driving and cell phone usage. Instructions Once printed, the 2 side channels need to be glued on. I made them very easy to glue with a portion of each channel that hugs the side, and another part that sits on the face. You can put superglue along the channel and put it right in place without any guesswork. To install this in the car, close the vent (push the louvers down) and put the top and side clips in first, then rotate the device clockwise to snap in the bottom clip. The spine in the back should sit along a seam to the left of the plastic dash. See images of my installed device. Please follow all applicable laws for driving and cell phone usage.