Iphone watch EvD

thingiverse

Turn that new iphone 4 into a watch Instructions print 1 dial, 1 male, 1 female, and however many band parts you will need. you will need two less pins and pin caps than the number of parts. simple construction. start from dial. band piece tab, insert pin, apply small amount of glue, apply pin stay, repeat until you get to the point watch band is left with roughly one inch of gap(2.54cm) add the male end to one and the female to the other. might take some adjustments to get to a good fit as this is based off of my wrist and I bet most people's aren't 8&1/2 inches around. After it fits pop in the ole iphone 4...